Filter
Top Products
Camera TV Software Data
69
TROUBLESHOOTING
h The batteries are exhausted.
h The batteries are not loaded correctly.
h
You use other batteries except alkeline ones.
No power.
h Put the batteries in your pocket or another
warm place to heat it and then load it into
the camera just before you take a picture.
h You are using the camera in extremely
cold conditions.
The batteries run out
quickly.
h Data is being recorded. Wait until the
viewfinder lamp turns green before
taking a picture.
h Wait until charging is completed (the
viewfinder lamp turns green) before
pressing the shutter button.
h Switch the camera on.
h Insert the new SmartMedia or delete
some unwanted frames.
h Wipe the SmartMedia contact area with
a clean dry cloth.
h Remove the write-protect stickers.
h Use the new SmartMedia. Or format the
SmartMedia.
h Data is being recorded (“6” is displayed
on the LCD or the viewfinder lamp is
flashing orange).
h You pressed the shutter button while the
flash was charging (The viewfinder lamp
lights orange).
h The Power Save function has switched
the camera off.
h The SmartMedia is fully recorded.
h The SmartMedia contact area (gold-
colored section) is soiled.
h The SmartMedia is write-protected.
h The SmartMedia is damaged.
No photograph is taken
when the shutter button
is pressed.
h Set the flash to
d
auto flash mode or
a forced flash mode.
h Replace the new alkaline batteries.
h The flash is set to s flash-off mode.
h The batteries are exhausted.
Can’t use the flash to
take picture.
h Move closer to the subject (0.8-2.0m).
h Hold the camera correctly.
h The subject is too far away.
h Your finger is obscuring the flash.
The playback image is
too dark even though the
flash was used.
Problem Cause Remedy
h Replace the new alkaline batteries.
h Load the batteries in the correct direction.
h Use the alkaline batteries only.