Filter
Top Products
44
To connect your camcorder to a TV without audio/video input jacks, follow
the steps below. You will need an optional 1CVA488 RF output adapter.
Optional accessories are shown on page 49.
Disconnect the VHF antenna from
your TV and connect it to the
optional RF output adapter.
A.If your antenna is a round 75-ohm
cable, connect it to the ANT
connector on RF output adapter.
B.If your antenna is a flat twin-lead,
connect the flat-lead connectors to
the screw terminals on an optional
300-75 ohm transformer, such as
193983. Then connect the
transformer to the ANT connector
on the RF output adapter.
Playback on a TV without Audio/Video Input Jacks
VIDEO AUDIO
VIDEO AUDIO
RF DC
DC IN 12V
BATT
EJECT
EJECT
OR
1
VHF
OR
3
VHF Antenna
3CH/4CH
Switch
RF Output
Adapter
(Optional)
Optional 300/75 ohm
Transformer
(Such as 193983)
AUDIO, VIDEO, and RF OUT
Jacks
(Located Behind Small Cover)
OR
2
VHF
VHF
Back of TV
(or VCR
Connected
to a TV)
Optional 75/300 ohm
Transformer
(Such as AH011)
(Located on
Opposite side)
1
ANT
OUT
Attach the OUT connector of the RF
output adapter directly to the VHF IN
terminal on the back of your TV.
Note: If your TV has VHF screw
terminals, you may need an optional
75-300 ohm transformer, such as AH011.
Connect the three-pronged plug end
of the RF output adapter to the
AUDIO, RF, and VIDEO OUT jacks
on the camcorder.
Installation
3
2
1