Filter
Top Products
Set the region
Along with the Language setting, the Region setting
determines the default date format and the format of the
video signal for displaying camera images on a
television when connected through an optional
HP Photosmart Premium camera dock or wireless dock
base (see Using the Setup Menu on page 39).
Use
to choose the region you want, then press
.
Set the date and time
1.
Use
to adjust the highlighted value.
2. Use
to move to the other selections and repeat
Step 1 until the date and time are set correctly.
3.
Press
when the date, time, and format settings
are correct, then press
again to confirm.
To change the date and time later, use the Setup
Menu (see Using the Setup Menu on page 39).
Install and format an optional memory card
1. Turn off the camera and open the Battery/Memory
card door.
2. Insert the optional memory card in the smaller slot
as shown. Make sure the memory card snaps into
place.
3. Close the Battery/Memory card door and turn on the
camera.
Always format memory cards before first use.
1.
With the camera turned on, press
until appears briefly in the upper right
corner of the Image Display. This indicates you are in Playback.
2.
Press
.
3.
Use
to select Format Card, then press .
4.
Use
to select Yes, then press to format the card.
Note Once you install a memory card, all new images and video clips are stored
on the card, rather than in internal memory. To use internal memory and view
images stored there, remove the memory card. To transfer images from internal
memory to an optional memory card, see Move Images to Card under Using the
Playback Menu on page 25.
For information about supported memory cards, see Storage under Specifications
on page 52.
Install the software
Note If you have trouble installing or using the HP Photosmart Software, see
the HP Customer Care website for more information: www.hp.com/support.
Chapter 1
8