Filter
Top Products
English
147
During playback
Focus is not correct. Is it difficult to use auto focus with your subject?
Focus manually.
53
Does manual focus icon appear?
The DVD video camera/recorder is set to manual focus. Focus
the subject manually, or release manual focus.
52
Is the dioptre control correctly adjusted if you are using the
viewfinder as a monitor?
Adjust the dioptre control.
31
In cases other than the above, set the power switch to “OFF”, and
then set it to “HDD”, “DVD” or “SD” again.
30
An error message for
repair appears.
Perform repair following the instructions on screen.
Repair is possible when the DVD video camera/recorder is powered
by the AC adapter/charger. If you are using the HDD and have
detected an error in part of video file, a battery can also be used for
repair (if the remaining battery level indicator shows more than half
level).
It will take from a few minutes to several hours for repair. If you
wish to start recording immediately, remove the disc, and then
insert another disc: The removed disc can later be repaired by
connecting the AC adapter/charger.
25
If during recording light
(sunlight, etc.) enters
the DVD video camera/
recorder through the
lens from above, ghosts
may occur in the
recorded image.
This is not a fault.
Adjust the angle of the DVD video camera/recorder so that sunlight,
etc. does not enter.
Putting a protective hand over the lens may improve the ghosts.
—
Symptom Cause and Correction
Reference
page
Recognition of disc is
not complete.
Is disc dirty?
Use the provided disc cleaning cloth to clean it.
10
Pressing the playback
button will not start
playback.
Has the image been recorded by devices other than this DVD
video camera/recorder?
Playback of image recorded on devices other than this DVD video
camera/recorder may be impossible on this DVD video camera/
recorder.
69
Has scene been edited on a device other than this DVD video
camera/recorder?
If a scene recorded on this DVD video camera/recorder is edited
on a device other than this DVD video camera/recorder, playback
may not be possible on this DVD video camera/recorder.
No playback picture
appears on TV screen.
Is TV input selector set correctly?
Some TVs have multiple video input jacks. Check whether the
correct input was selected on TV to match the connected jacks. If
the DVD video camera/recorder is connected to VCR, set its
input selector to “external input (LINE)”.
113
Is the DVD video camera/recorder connected to TV correctly?
Check the connections.
112
Symptom Cause and Correction
Reference
page