Filter
Top Products
148
*1
• This message may also appear when dirt adheres to disc. If this message appears when a recorded disc is
recognized immediately after it is inserted, do not repair the disc; remove it and then use the provided disc
cleaning cloth to clean off the dirt before using it.
• This message may also appear when condensation occurs. In this case, do not repair the disc; turn the DVD video
camera/recorder off, wait until it dries out, and then turn it on again.
• If the repair message appears when you turn the DVD video camera/recorder on from off with a disc loaded
after recording on it, choose repair.
• If the repair message appears when recording and playback are normally possible with another disc – and no
condensation occurs and the disc is not dirty – choose repair.
*2
• This message may also appear when dirt adheres to disc. In this case, do not initialize the disc: Remove it and
then use the provided disc cleaning cloth to clean off the dirt before using it.
• This message may also appear when condensation occurs. In this case, do not initialize the disc; turn the DVD
video camera/recorder off, wait until it dries out, and then turn it on again.
• Initialization will delete all data on disc.
*3
• This message may also appear when dirt adheres to disc. Remove the disc and then use the provided disc
cleaning cloth to clean off the dirt before using it.
• This message may also appear when condensation occurs. Wait until the DVD video camera/recorder dries out,
and then turn it on again.
*4
• This message will appear when a single-sided disc is inserted in reverse. Reinsert the disc correctly. (Insert the
disc with the label printed surface facing the outside.)
*5
• Do not insert a DVD-RW (VF-mode)/DVD-R that has not been finalized into any DVD recorder: The disc may be
unusable.
This DVD cannot be
used. Please replace
DVD.
A disc that cannot be used on this DVD video camera/recorder
has been loaded. Check the type of disc. 27
This DVD is finalized.
Finalize is not required.
This message will appear if you press the FINALIZE button with a
finalized DVD-RW/DVD-R/+RW loaded in this DVD video camera/
recorder. Finalizing the disc is not necessary.
112
This DVD is recorded by
the PAL system. Please
replace DVD.
This DVD video camera/recorder can use only discs recorded on
the NTSC system. A disc recorded on the PAL system cannot be
used on this DVD video camera/recorder.
—
UNFORMAT DVD The disc is not initialized or it is damaged.
If this message appears, be sure to initialize the disc on this DVD
video camera/recorder before using it.
Reinitializing even a disc used on this DVD video camera/
recorder may be necessary (initializing will erase all recorded
contents on disc). If this message appears, try to initialize the
disc. If the same message still appears, the disc may be
damaged: Use another disc.
109
See *2 on this page. 11
UNFORMAT HDD The HDD may not be initialized, or it may be destroyed. —
Use AC adapter/
charger.
No dubbing, HDD deletion, or disc finalization is possible with a
battery: Use the AC adapter/charger.
28, 84, 111,
112
Use AC adapter/
charger.
Turn off power.
Scene cannot be repaired when the DVD video camera/recorder
is powered by a battery.
If the AC adapter/charger is unavailable in handy place, remove
the disc, use the opposite side, or use another disc. To repair the
removed disc, insert the disc into the DVD video camera/recorder
afterwards, and connect the AC adapter/charger.
28
Write protected.
Check card.
A card with the erase prevention switch locked is inserted: Unlock
the switch.
27
Write protected.
Check HDD/DVD.
The HDD or disc is write-protected. Use the Disc Navigation
menu to release the protection.
110
Message Cause & Troubleshooting
Reference
page