44
English
REMOVING DISC
1Set the power switch to
“POWER OFF” to turn the
DVD video camera/
recorder off.
2Press down the DISC
EJECT button once and
release it.
In a moment, the cover of
disc insertion block will
open slightly.
3Gently open the cover until
it stops.
When the cover is fully
open, the disc will slightly
come out from the disc
guide, and stop.
4Remove the
disc.
Hold the top
of Round
DVD
Holder as
shown in the
illustration and gently pull it out.
Note:
Be careful not to touch the disc exposed portion when
removing the disc.
5Gently push the section
indicated “PUSH CLOSE”
on the cover of disc insertion
block, to close the cover.
Note:
• It is recommended that you turn the DVD video camera/
recorder off when inserting or removing disc, in order to
prevent faulty operation.
• Even after the DVD video camera/recorder is turned on,
the disc can be removed unless it is in recording status.
Hold down the DISC EJECT button for approximately 2
seconds, and then release it to remove the disc (The
DISC EJECT indicator on the LCD screen will blink.). It is
recommended that you turn the DVD video camera/
recorder off before inserting or removing disc to prevent
misoperation.
• Do not detach the battery or AC adapter/charger until the
DVD video camera/recorder is completely turned off.
• Do not insert anything other than the 8 cm DVD-RAM or
DVD-R disc into the disc insertion block: Doing so could
cause malfunctions.
• Set the power switch to “POWER OFF” to turn the DVD
video camera/recorder off.
• When inserting or removing the disc, be careful not to
touch the inside of DVD video camera/recorder
(especially, the lens of laser pickup).
• When inserting or removing the disc, connect a charged
battery or AC adapter/charger to the DVD video camera/
recorder: The disc cover will not open unless the DVD
video camera/recorder is powered.
DISC EJECT
Hold disc
around this
portion.