Filter
Top Products
English
38
1<>2/
Inserting and Removing Disc
1
Set the power switch to “DVD” or “OFF” .
When the power switch is set to “HDD” or
“SD”, the cover of disc insertion block will
not open. When “Please insert DVD.” appears
during dubbing, however, the cover of disc
insertion block will open even when the
power switch is set to “HDD” (see p. 80).
2 Press down the DISC EJECT button once and
release it.
A few moments after the ACCESS/PC
indicator blinks, the cover of disc insertion
block will open.
3 Gently open the cover by hand fully until it
stops.
4 When inserting a disc:
Push the disc against the turntable at the
center to lock it until a click is heard.
When removing the disc:
While pushing down the center portion of
turntable, pick up the disc, holding its edge,
to remove it.
• Note that the recording surface of disc must face
the inside of DVD video camera/recorder. When
using a single-sided disc, the recording surface is
the side without label.
• Never touch the disc recording surface or pickup
lens. Touching the pickup lens could cause a fault.
• Use the disc cleaning cloth provided to wipe off
any dirt adhering to the disc recording surface.
• Do not use a dirtied or scratched disc.
5 Push the section marked “PUSH CLOSE” on
the cover of disc insertion block, to close the
cover.
Then the DVD video camera/recorder will
automatically recognize the disc: While the
ACCESS/PC indicator is lit, do not cut off the
power supply, and do not subject the DVD
video camera/recorder to any vibrations or
impact.
Push the shaded
portion.
Tu rn ta bl e
Pickup lens