Filter
Top Products
ATTACHING THE OPTIONAL TELE OR WIDE CONVERTER LENS - 53 -
To replace the front case, pass the lamp through the hole of the reflection plate then attach the upper hooks
to the camera light, and then attach the lower hook to the camera light.
NOTES:
• Do not touch the lamp directly with your fingers. It may shorten its service life.
• When the lamp is replaced, or when the front case of the camera light is removed, make sure the front case is
attached to the camera light properly.
• Consult your nearest service center to replace the lamp.
ATTACHING THE OPTIONAL TELE OR WIDE CONVERTER LENS
1. Remove the lens hood.
Turn the lens hood counterclockwise as shown in the figure.
Or, attach the lens cap over the lens hood, then turn them counterclockwise to remove them.
2. Remove both caps of the telephoto or wide angle lens.
3. Screw the lens into the threads on the front of camcorder lens assembly.