Filter
Top Products
Advanced Techniques - 36 -
Using Synchro Edit
Use synchro edit to record segments of a previously recorded tape when dubbing from the camcorder to a VCR.
This requires an optional synchro edit cable. The Hitachi VM-E220A uses a flying erase head to eliminate glitches
or rainbow noise that sometimes occurs between edits. Your VCR must have the EDIT IN jack to use the synchro
edit.
Synchro Edit Hookup Illustration
1. Connect the synchro edit cable to the AV IN/OUT jack of your camcorder.
2. Connect the synchro edit cable to the AUDIO IN, VIDEO IN, and EDIT IN jacks of your VCR. Connect either the
right or left audio plug into your VCR if it has only one AUDIO IN jack.
Turn on your VCR and place it in the camcorder input mode (consult your VCR manual for details).
3. Insert the recorded tape in the camcorder and a blank tape into the VCR.
4. Play the tape in the camcorder until you find the place you want to record. Press the Start/Stop button.
5. Press the Record button on the VCR. It automatically sets to pause. If the VCR begins to record instead of
pausing you need to change the position of the polarity switch on the synchro edit cable. Stop the VCR, change
the position of the switch, and press the Record button on the VCR.
6. Press the S.EDIT button on the remote control and the last few seconds of the recorded tape reviews in the
viewfinder and then the camcorder is placed in playback. The recording VCR starts recording automatically.
7. Press the F.FWD, REW, STOP, and Start/Stop buttons to pause the VCR. You can then search forward or
back through the tape without affecting the tape in the VCR.
Use the F.FWD and REW buttons to search the tape. Press the PLAY button to resume normal playback. To
resume recording on the tape in the VCR, press the Start/Stop button and then the S.EDIT button.
To fast forward or rewind the tape, press the STOP button, then F.FWD or REW. To return to recording on the
tape in the VCR, press the STOP button, then the PLAY button, then the Start/Stop button, and then the S.EDIT
button.
8. To stop recording at a certain point turn on the camcorder's linear time counter with memory ("Using Memory,"
p.42). Press the COUNTER RESET button on the remote control where you wish the recording to stop. The linear
time counter resets to 0:00:00M. Rewind to the point where you wish to start recording and start copying. When
the linear time counter reaches 0:00:00 the recording stops automatically, pausing the VCR in the record mode.
Note: If the tape counter reads "0:00:00M" you cannot start recording.
Simple Programmable Edit (Edit remote control is optional accessory)
Simple programmable edit allows you to program your camcorder to select the scenes you want to copy from a
pre-recorded tape. Use the edit remote control (optional) to easily copy scenes from a recorded tape in the
camcorder (playback machine) onto a blank tape in a table-top VCR which handles infrared signals (recording
machine).
Note: Only the VM-RM20EDA edit remote control (optional) can be used with this camcorder.
Note: Some VCRs cannot be operated by the edit remote control (optional).
Example of Programmable Editing
Programming the Remote Control for the VCR
It is necessary to program the edit remote control to match the VCR before starting editing.