Filter
Top Products
DATE/TIME SETTING
22
DATE/TIME SETTING
1
The date and time can be recorded on your tapes to act as a handy reference when viewing them at a
later time. Use the following procedure to set up this display for the current date and time.
1. Load the camera/recorder's date/time battery as described on page 10.
2. Press and hold small red button in the power switch, and then slide it to "CAMERA" position.
3. Press "DATE" button. Date and time appear in the viewfinder and "1" flashes.
4. Press "F.FWD" button to select correct month. Hold button down to advance rapidly. If you go past
the month you want to set, press "REW" button. When the correct month appears, press "STOP"
button.
5. Press "F.FWD" button to select correct date. Hold button down to advance rapidly. If you go past the
date you want to set, press "REW" button. When the correct date appears, press "STOP" button.
6. Press "F.FWD" or "REW" button to select year, and then press "STOP" button.
7. Press "F.FWD" or "REW" button as many times as may be required to select correct hour, and then
press "STOP" button.
8. Repeat step 7 to select minute and AM/PM.
9. After setting AM or PM, press "STOP" button again to erase the flashing cursor and start the internal
clock.