Filter
Top Products
VIEWING THE PICTURE PLAYED BACK ON YOUR TV
43
Example 3: If your TV is a regular TV,
Camera hookup to regular TV Illustration
1. Disconnect the VHF antenna leads from the rear of the TV receiver.
NOTE: Leave the UHF antenna leads connected to the TV.
2. Connect the VHF antenna lead to "IN FROM ANT" on the RF output adapter. If the cable is
round (75-ohm), it will connect direcly to the "IN FROM ANT". If it is the flat type (300-ohm),
connect it to the antenna adapter (300-ohm to 75-ohm) and slip the adapter on to the "IN FROM
ANT" terminal.
3. Connect the 75-ohm coaxial cable to "OUT TO TV" on the RF output adapter.
4. Connect the other end of the VHF antenna terminal on the TV, as illustrated.
5. Connect the connector cable from RF output adapter to "AV IN/OUT" jack on the
camera/recorder.
6. Turn on the TV and set to channel 3 unless channel 3 is one of the TV stations in your area. If
channel 3 is used in your area, set your TV to channel 4.
7. Set the RF channel select switch on the RF output adapter to "CH3" or "CH4" to match the
channel selector on your TV.
8. Perform same procedures in steps 4 through 7 of "Example 1".
NOTE: If you want to watch a TV program with camera/recorder connected as illustrated, slide the
power switch of the camera/recorder to off.