Filter
Top Products
VIEWING THE PICTURE PLAYED BACK ON YOUR TV
42
VIEWING THE PICTURE PLAYED BACK ON YOUR TV
To play back a tape recorded on your camera/recorder and view it on your TV receiver, you
must connect the camera/recorder to the TV receiver using either AV stereo output cord
(provided) or RF output adapter (provided).
Example 1: If your TV is already connected to the VCR,
1. Connect the AV stereo output cord (provided) to "AUDIO IN" and "VIDEO IN" of your VCR.
NOTES:
• If your VCR has a single (mono) audio input, connect either the left or right audio plug to the audio
input of the VCR.
• If your VCR has an "S-VIDEO IN" jack, connect the "S-VIDEO" plug (black) to the VCR instead of
the "VIDEO IN" plug (yellow)
2. Connect the other end to the AV stereo output cord to "AV IN/OUT" of your camera/recorder.
3. Select the "LINE" of your VCR.
4. Slide "EJECT" switch on the camera/recorder and then insert the cassette.
5. Slide the power switch to "VIDEO".
6. Press "PLAY" button.
7. After playing press "STOP" button.
Example 2: If your TV has "VIDEO IN" and "AUDIO IN" jacks,
1. Connect the AV stereo output cord (provided) to "AUDIO IN" and "VIDEO IN" of your TV.
NOTES:
• If your TV has a single (mono) audio input, connect either the left or right audio plug to the audio
input on the TV.
• If your TV has an "S-VIDEO IN" jack, connect the "S-VIDEO" plug (black) to the TV instead of the
"VIDEO IN" plug (yellow).
2. Connect the other end of the AV stereo output cord to "AV IN/OUT" of your camera/recorder.
3. Turn on TV.
4. Perform same procedures in steps 4 through 7 of "Example 1" above.