Filter
Top Products
Simple Programmable Edit (Edit remote control is optional accessory)
57
1. Turn the VCR on.
2. Aim the remote control at the infrared receiver on the VCR and press the VCR SET
button on the remote control and hold it, then press the button corresponding to the
VCR's maker code. For example, if you have a RCA VCR, press the VCR SET button
and hold it, then press the DISPLAY button. To check whether the remote control code
matches that of your VCR or not, point the remote control at the infrared receiver on the
VCR and press the VCR SET button and hold it. If the remote control code has been
set, the VCR channel is counted up automatically.
Note: Your VCR should have an infrared remote control.
Note: If the channel on the VCR does not change with the above operation, you need to
switch the remote control code of your VCR. Refer to the VCR's instruction manual. If the
channel still does not change after you have changed the VCR's remote control code, the
edit remote control cannot operate your VCR.
VCR Brands Press VCR SET and This Button
Hitachi REVERSE
Sony PROGRAM
Panasonic FORWARD
Toshiba IN
Mitsubishi COPY START
Sanyo OUT
Sharp
NEC
JVC
Akai A/V DUB