Filter
Top Products
Simple Programmable Edit (Edit remote control is optional accessory)
59
PROG. 1 0: 00 : 02
IN - : - - : - -
OUT - : - - : - -
Note: If your VCR is connected to a TV, the program display will also appear on the TV
screen.
5. Press the button and use the or button to search for the starting point of the
segment you want to copy. Press and then to set the camcorder to the play pause
mode.
The linear time counter counts when searching for the starting point.
Use the FORWARD and REVERSE buttons in the play or pause mode to fine adjust the
tape position. Press FORWARD and hold it; the tape is played while the button is held.
Press REVERSE and hold it for reverse play.
6. Press the IN button to store the counter reading. When you press the IN button, OUT
flashes in the program display.
PROG. 1 0: 15 : 13
IN 0: 15 : 13
OUT - : - - : - -
7. Press the button to search for the end of the segment you want to copy. Press
and then to set the camcorder to the play pause mode. Use the FORWARD or
REVERSE button as required to fine adjust the tape position.
8. Press the OUT button to store the counter reading at the end of the scene.
PROG. 2 0: 20 : 15
IN - : - - : - -
OUT - : - - : - -
9. Continue programming as described above until you have entered up to four different
segments.
10. Load a blank tape, then set the VCR to the record pause mode.
11. Point the remote control at the receiver on the VCR and press the COPY START
button to start simple programmable edit.
• The camcorder automatically searches for the beginning of the first segment and starts
playback. The recording VCR automatically starts recording
• After recording the first segment, the camcorder automatically searches for the