Filter
Top Products
18
Installation and Setup
Camera Installation
Preparing the Camera
1. Rotate the bubble counterclockwise until it
disconnects.
2. Pull the turret to remove it.
3. Rotate the camera counterclockwise until it
disconnects from the skirt.
4. Set aside the bubble, turret, and camera.
Preparing the Mounting Surface
1. Mark the mounting surface for screw holes and wire access hole.
• Use the mounting template if you are surface mounting your camera. See
Mounting Template on page 65
• Use the flush mount adapter plate as a template if you are flush mounting your
camera.
Figure 2-2 Mounting Template
Skirt
Bubble
Camera
Turret
Drill these holes for the
mounting screws.
Cut this hole, then pull the
power, audio, and alarm
wires through it.