Filter
Top Products
12
Introduction
Side Terminal
A [HD/SD-SDI] HD/SD-SDI Output Terminal (BNC)
(A Page 114)
B [Y/VIDEO] Y/Composite Video Signal Output
Terminal (BNC) (A Page 114)
C [PB] PB Video Signal Output Terminal (BNC)
(A Page 114)
D [PR] PR Video Signal Output Terminal (BNC)
(A Page 114)
E [REMOTE] Remote Terminal (A Page 119)
F [DC INPUT] DC Input Terminal (A Page 21)
Input terminal for DC 12 V power supply. Connects with an
AC adapter.
G [AUDIO OUTPUT] Audio Output Terminal (RCA)
Output terminal for audio signals.
● Input audio signals are output during Camera mode.
● Playback audio signals are output during Media mode.
● Audio from input audio signals is output during HD/DV
signal (IEEE1394) input.
Memo:
● Alarm tone is not output.
H [HD/DV] IEEE1394 Terminal Mode Switch
(A Page 115)
I [INT/EXT] IEEE1394 Interface Terminal Switch
(A Page 115)
For selecting a valid IEEE1394 interface terminal.
J Shoulder Pad Slide Button
For adjusting the shoulder pad position. Press this button to
adjust the shoulder pad K position to the front or back.
K Shoulder Pad
L [USB] USB Terminal (A Page 118)
M [IEEE1394] IEEE1394 Terminal (4-pin)
For connecting digital video equipment with IEEE1394
terminal using an IEEE1394 cable (sold separately).
To enable this terminal, set the [INT/EXT] IEEE1394 terminal
switch I to [EXT].
(A Page 115 [IEEE1394 Connection])
(A Page 117 [Stream Transmission to a Non-linear Editing
System])
Note:
● When connecting IEEE1394 cables, check that the
connectors are facing the right direction before you insert.
Memo:
● Put on the covers when the connectors are not in use.
Names of Parts (continued)
[EXT]
: Enables IEEE1394 signals from the [IEEE1394]
terminal M.
[INT]
: Enables the accessory connector B at the rear
of the camera recorder. (A Page 13)
A
C
E
F
G
D
B
HI
J
K
L
M