Filter
Top Products
52
Shooting
Ⅵ When [Manual] is selected
A [SPOT METER FIXED] is displayed when the switch is
flipped. The brightness of the cursor position is displayed.
B [SPOT METER OFF] is displayed when the switch is
flipped. Displays of cursors and brightness disappear.
C [SPOT METER SELECT] is displayed when the switch is
flipped. The cursor blinks in red.
Move the cursor with the cross-shaped button (
JKH I) to
specify the position to display the brightness. When the
position is decided, press the Set button (
R) or flip the
switch to confirm.
D Returns to the state in A.
Memo:
● When moving the cursor position, [SHUTTER]/[AE
LEVEL] control is disabled.
● You can also decide the position of the cursor with the Set
button (
R).
● When the brightness is 0 % in the entire screen, the frame
is fixed in the center.
You can check (review) the last recorded video clip on the
screen.
However, the video clip cannot be played back if the settings
of the camera recorder are different from the video format
(Camera Resolution/Frame & Bit Rate) of the clip.
(A Page 71)
Memo:
● To use this function, assign AClip ReviewB to any of the
[USER1], [USER2], [USER3] buttons or the [RET] button
on the lens.
* [Main Menu]B[Camera Function]B[Switch Set]B[LENS
RET]/[USER1]/[USER2]/[USER3]BAClip ReviewB
(A Page 74)
1 Press the button assigned with the AClip ReviewB
function during standby (ASTBYB is displayed).
Playback of the configured section starts.
Memo:
● The video clip is played back according to the [Clip
Review] settings in the [Camera Function] menu. By
default setting (Last 5 sec), the last 5 seconds of the clip is
played back. (A Page 74)
● When playback is complete, the camera recorder exits
Clip Review and returns to ASTBYB (recording standby)
mode.
Setting Spot Meter
(continued)
Cursor (Green)
Cursor
(Blinks in red)
Viewing Recorded Videos
Immediately (Clip Review)
RET
IRIS
A
M
W
T
[RET] Button