Filter
Top Products
14
Introduction
Zoom Lens
(Supplied with GY-HM700U/GY-HM700E only)
A Focus Ring
B Zoom Lever/Ring
To operate zoom with this lever, turn the [ZOOM] switch M
and set it to AMANU.B.
C Iris Ring
To operate auto iris, set the iris mode switch H to AAB.
D Lens Cable
E [REC] Record Trigger Button
Starts/stops recording.
F [RET] Return Video Button
Press this button to play back and check the latest clip,
according to the settings under [Clip Review] of [Switch Set]
in the [Camera Function] menu. (A Page 74)
(A Page 52 [Viewing Recorded Videos Immediately (Clip
Review)])
Memo:
● When [LENS RET] of [Switch Set] in the [Camera
Function] menu is set to AFocus AssistB, this button
functions as the Focus Assist button. (A Page 74)
G Zoom Servo Control Lever
To operate zoom servo with the zoom servo control lever, set
the [ZOOM] switch M to ASERVOB.
● Zooms into wide angle and increases the angle of view
when AWB is pressed.
● Zooms into telephoto and decreases the angle of view
when ATB is pressed.
● Zoom speed increases when the lever is pressed hard.
H Iris Mode Switch
I Iris Momentary Button
Press and hold this button to change to auto iris mode when
the iris mode switch H is set at AMB.
J [I.G.] Iris Speed Adjustment Knob
If the speed is set too fast, opening/closing of the iris
becomes unstable and hunting may occur. Readjust the
speed in this case.
K Filter Built-In Screw
A transparent or UV filter for lens protection can be installed
inside the lens hood from the front. Filters for various effects
can also be used.
● Installable filter types
L Zoom Servo Connector
For connecting a zoom servo unit (sold separately).
M [ZOOM] Zoom Switch
N Back Focus Ring/Lock Screw
Exclusive ring for adjusting the back focus. After adjusting,
secure with a lock screw.
(A Page 27 [Adjusting Back Focus])
O [M] Macro Focus Ring (for close-ups)
Turn the ring in the direction of the arrow to take close-up
shots of small objects.
Normal focusing and zooming cannot be performed in macro
mode.
To take macro shots
● Set focus ring A to infinity (n).
● Set zoom ring B to the maximum wide angle.
● Rotate this ring in the direction of the arrow to adjust
focus on the object.
Note:
● As the back focus knob is located nearby, be careful not to
mistake the two knobs.
● Do not forget to restore the macro ring to its original
position after use. (A Page 27 [Adjusting Back Focus])
Names of Parts (continued)
M
RET
IRIS
A M
W
T
R
E
C
H
ABC
I
GFE
NL O
D
J
K
M
A
N
U
.
S
E
R
V
O
ZOOM
M
CANON KT14 x 4.4KRSJ
A
: Auto iris operation mode.
M
: Manual iris operation mode.
When installed on the hood : 82mmP0.75
When installed on the lens body : 72mmP0.75
SERVO
: Enables zooming with the zoom servo control
lever G.
MANU.
: Enables zooming with the zoom lever/ring B.