Filter
Top Products
EN69
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
29.
•“DISPLAY” is set to “OFF” in the
Date/Time Menu.
•Interface shooting is performed.
30.
•“ON SCREEN” is set to “OFF” in
the Date/Time Menu.
•You have made the indicators
disappear.
31.
•In places subject to low
temperature, images become dark
due to the characteristics of the
LCD monitor. When this
happens, the displayed colors
differ from those that are actually
recorded. This is not a defect of
the camcorder.
•When the LCD monitor's
fluorescent light reaches the end
of its service life, images on the
LCD monitor become dark.
Consult your nearest JVC dealer.
32.
•The light used to illuminate the
LCD monitor causes it to
become hot.
33.
•This may occur when the
surface or the edge of the LCD
monitor is pressed.
34.
•Certain Fade/Wipe effects, certain
modes of Program AE with
special effects, “DIS” and other
functions that cannot be used
together are selected at the same
time.
35.
•The LCD monitor or the
viewfinder is made with high-
precision technology. However,
black spots or bright spots of
light (red, green or blue) may
appear constantly on the LCD
monitor or the viewfinder. These
spots are not recorded on the
tape. This is not due to any
defect of the unit. (Effective
dots: more than 99.99 %)
36.
•The optional headphones are not
connected to the headphones
connector.
•The sound volume of the
headphones connector was not
adjusted appropriately. The sound
volume at this point is the same
as the level it was adjusted to
during playback.
29.
• Set “DISPLAY” to “ON” in the
Date/Time Menu (
੬ pg. 20).
• During interface shooting, the
date/time does not appear
(
੬ pg. 17).
• Press IND. ON/OFF for longer
than 1 second to make the
indicators appear (
੬ pg. 15).
30.
• Set “ON SCREEN” to “ON” in
the Date/Time Menu (
੬ pg. 20).
• Press IND. ON/OFF for longer
than 1 second to make the
indicators appear (
੬ pg. 15).
31.
• Adjust the brightness and angle
of the LCD monitor (
੬ pg. 17).
32.
• Close the LCD monitor to turn it
off or set the Power Switch to
“OFF”, and let the unit cool
down.
33.
————
34.
• Re-read the sections covering
Fade/Wipe effects, Program AE
with special effects and “DIS”
(
੬ pg. 29, 31–35).
35.
————
36.
• Connect the optional head-
phones to the headphones
connector (
੬ pg. 64).
• Adjust the sound volume during
playback (
੬ pg. 43).
29.
During recording, the date/
time does not appear.
30.
The indicators and messages
do not appear.
31.
Images on the LCD monitor
appear dark or whitish.
32.
The rear of the LCD monitor is
hot.
33.
The indicators and the image
colour on the LCD monitor are
not clear.
34.
The LCD monitor or
viewfinder indications blink.
35.
Colored bright spots appear all
over the LCD monitor or the
viewfinder.
36.
During recording, sound
cannot be heard.
CONTINUED ON NEXT PAGE