Filter
Top Products
8 EN
5S
P
L
A
Y
O
F
F
ON SCREEN OFF
ONDISPLAY
4
DATE / TIME
1 . 1 . 00
00 : 00
RETURN
– – – – –6– – – – –
REC MODE
WIDE MODE OFF
40X
SP
ZOOM
FLASH
GAIN UP
DIS
4
TO DATE / TIME MENU
TO SYSTEM MENU
END
OFF
AGC
AUTO
Date/Time Settings
Date and time will automatically be recorded on tape at
all times. It is your choice to display it or not during
playback (੬ pg. 47).
1
SELECT OPERATION MODE
Set the Power Switch to “ ”, “5S” or “ ” while
pressing down the Lock Button located on the switch,
and open the LCD monitor fully or pull out the
viewfinder fully.
•The power lamp comes on and the camcorder is
turned on.
2
ACCESS RECORDING MENU
Press MENU. The Recording Menu appears.
3
ACCESS DATE/TIME MENU
Move the highlight bar to “TO DATE/TIME MENU”
by rotating the Select Dial. Press the Select Dial and
the Date/Time Menu appears.
4
INPUT DATE AND TIME
Move the highlight bar to “DATE/TIME” by rotating
the Select Dial. Press the Select Dial and “day” is
highlighted and begins blinking.
Rotating the Select Dial, input the day. Press the
Select Dial. Repeat the procedure to input the month,
year, hour and minute.
•Press the Select Dial twice when the highlight bar is
set to “RETURN” to exit.
Regarding Built-in Clock’s Rechargeable Lithium
Battery
To store the date/time in memory, a clock’s rechargeable
lithium battery is integrated in the camcorder. While the
camcorder is connected to an AC outlet using the AC
Power Adapter/Charger, or while the battery pack attached
to the camcorder continues to supply power to the
camcorder, the clock’s rechargeable lithium battery is
always charged. However, if the camcorder is not used for
approx. 3 months, the clock lithium battery will become
discharged and the date/time stored in memory will be
lost. When this occurs, first connect the camcorder to an
AC outlet using the AC Power Adapter/Charger etc. for
over 24 hours to charge the clock’s rechargeable lithium
battery. Then perform the date/time setting before using the
camcorder.
It is also possible to use the camcorder without the date/
time setting.
NOTE:
Even if you select “DATE/TIME”, if the parameter is not
highlighted the camcorder's internal clock continues to
operate. Once you move the highlight bar to the first date/
time parameter (day), the clock stops. When you finish
setting the minute and press the Select Dial, the date and
time begin operation from the date and time you just set.
GETTING STARTED
(cont.)
Power lamp
Recording Menu
Display
Date/Time Menu
Select Dial
MENU Button
Power Switch
Lock Button