Filter
Top Products
Unpacking Instructions for the
KODAK PROFESSIONAL
HR 500 Film Scanner
CAUTION: The HR 500 Film Scanner weighs almost 120 lbs (54,5 kg). Two people are needed to safely lift the
scanner from the box.
Be sure the table for the scanner:
• is stable
• can support approximately 120 lbs (54,5 kg)
• is at least 30 in. (76,2 cm) long x 30 in. (76,2 cm) wide
August 2001 iii
1. Inspect the box to make sure there is no damage.
If there is damage, contact the shipping company.
2. Remove the lid from the box.
3. Remove the scanner accessories (such as cables
and SCSI board) from the front compartment of the
box.
4. Compare the packing list to the actual contents.
If there is an item missing:
• In the United States: call Eastman Kodak
Company at 1-800-822-1414.
• Outside the United States: contact your local
Kodak representative.
5. Open the plastic bag that covers the scanner and
move the bag so you can reach the cutouts in the
styrofoam under the scanner.
CAUTION: Two people are needed to lift the scanner
from the box.
6. Use the styrofoam cutouts to reach under the
scanner (one person in front; one person in the rear)
and lift the scanner out of the box onto the table.
7. Keep the scanner packing material until you are
satisfied that the scanner is operating satisfactorily.
CAUTION: Make sure the setting on the AC input
module on the back of the scanner is
compatible with the power source.
lid
styrofoam
scanner in
plastic bag
styrofoam
under scanner
front
compartment
with
accessories
cutouts