Filter
Top Products
Using the Long Roll Accessory
August 2001 D-3
Upgrading the Scanner’s Firmware
NOTE: Check the Web site (see page D-2) for the most up-to-date instructions.
1. Open SAM and click the Transfer tab on the Operations window.
2. Make sure the File Type is Firmware (W).
3. Click Browse (in the Service Files area) and find the .zip file that you
downloaded from KODAK.COM (example: HR500\Px01_700.zip).
4. Click Open.
5. Make sure the Scanner Directory is set to Current.
6. Click To Scanner to start the transfer.
The transfer takes approximately one minute.