Konica Minolta 9 Digital Camera User Manual


 
DRIVE – Self-Timer
5756
5. Center your subject in the focus
frame, then press the shutter-
release button part way down to
confirm the focus.
The shutter will be released even if the focus is
not confirmed.
6. Press the shutter-release button all
the way down to start the timer.
(10 sec) – The self-timer indicator on the
front of the camera will blink
slowly, then blink rapidly just
before the shutter releases.
Turn the main switch to LOCK
or select another drive mode to
cancel the 10 sec self timer.
(2 sec) – The mirror pops up when the
shutter release button is pressed
all-the-way down. The shutter is
released two seconds later.
The 2 second self timer cannot
be cancelled.
2. Open the control panel door and
press the adjust button.
1. Place the camera on a tripod, then turn
the drive-mode lever to
.
Use the self-timer to delay the shutter release for 2 or 10 seconds (approx.) after
the shutter-release button is pressed all the way down. In addition to delaying
release of the shutter, the 2 second delay pops the mirror up two seconds before
the shutter opens to reduce blur caused by camera vibration.
The red-eye reduction flash mode is not effective when the 2 second self timer is
selected.
Close the eyepiece shutter (p.79) to prevent a bright light source behind the camera from
interfering with the exposure.
3. Turn either control dial until the
desired delay appears in the data
panel.
4. Press the shutter-release button
partway down to enter the
selection.
DRIVE