Konica Minolta 9 Digital Camera User Manual


 
TROUBLE SHOOTING
109108
SOLUTION PAGE
Remove and reinstall the batteries.
If the camera battery is exhausted, install a new battery.
10
10
18
-
99
Contact your nearest Minolta Service Facility if the problem you are experiencing is not
covered or the condition continues.
Use focus hold or manual focus.
Slide the focus-mode switch to AF.
Check the minimum focus distance for your lens.
21/33
Use focus hold or manual focus.
Set Custom Function 16 to setting 2.
21/33
Set Custom Function 5 to setting 1. 94
Make sure the subject is within the flash range. 23
Remove lens hood.
The distance between the subject and the camera must be at least
1m (3.3ft.) when the built-in flash is used.
-
Remove and reinstall the batteries. If normal camera operation does
not resume or the camera malfunctions repeatedly, contact an
authorized Minolta Service Facility.
10
PROBLEM CAUSE
No display appears
when the camera is
switched on.
Batteries are loaded incorrectly.
Batteries are exhausted.
Autofocus does not work
when shutter-release
button is pressed
partway down.
Situation is unsuitable for autofocus.
Camera is set to manual focus mode.
Subject is too close.
Shutter cannot be
released.
Focus cannot be confirmed.
Camera is attached to a microscope or telescope.
Custom Function 5 set to setting 2.
Flash picture is too dark. Subject is beyond flash range.
Lower part of flash
picture is dark.
Lens hood attached.
Err appears in the data
panel.
Camera Malfunction
APPENDIX