99
Move the controller left and right to dis-
play the image to be printed.
The number of prints in the print run are displayed as well as the
print parameters selected with the menu. See the menu naviga-
tion section in the page 100 for more information. Press the con-
troller to begin printing, or press the menu button to return to the
PictBridge screen.
Repeat the previous steps until all the
images to be printed are selected. Press
the controller to continue. If the number
of images exceeds 50, “Limit:50 images.
Reselect images to print.“ message
appears. Reduce the number of images.
Move the controller up to select the num-
ber of copies to be printed. A maximum
of twenty copies can be selected. To des-
elect an image for printing, move the
controller down until the number of
copies reaches zero.
Once printing begins, the operation can be canceled by pressing
the controller. The printing finished message indicates the end of
the operation; turn the camera off to end the routine.
Number of prints in the print run.
:move :sel. :print
Connect the camera to the printer using the camera’s USB cable. The larger plug
on the cable is connected to the printer. Slide open the USB-port cover and insert
the smaller plug of the cable into the camera. Turn the camera on. The PictBridge
screen will be displayed. For other printing options, see the menu navigation sec-
tion.
Number of copies of the displayed image.
No. of prints
Paper size
Data print
: 7
Print quality
Layout
:start
:Printer setup
:Printer setup
:Printer setup
:Printer setup
Printing finished.
OK