Filter
Top Products
Preparation
16
Inserting/Removing the Card
• Check that the camera is turned off and
that the lens is retracted.
• Close the flash.
1
Slide the card/battery door to
open it.
2
Insert:
Insert the card with the label side
facing the back of the camera
until it clicks.
Remove:
Push the card until it clicks, then
pull the card out upright.
• Check the direction of the card.
3
1 Close the card/battery door.
2 Slide the card/battery door to
the end and then close it firmly.
• If the card/battery door cannot be
completely closed, remove the card and
insert it again.
• The card and the data may be damaged if it is inserted or removed while the camera
is on.
•
Use only the genuine SD card with SD Logo.
• Do not touch the connection terminals on the back side of the card.
• The card may be damaged if it is not fully inserted.
2
1