Filter
Top Products
Setup
Initial setup should be performed using the supplied Windows-based setup Wizard. This
program can locate the LevelOne IP Network Camera even if its IP address is invalid for your
network. You can then configure the LevelOne IP Network Camera with appropriate TCP/IP
settings for your LAN.
Subsequent administration can be performed with your Web browser, as explained in Chapter
3 - Web-based Administration.
Setup Procedure
1. Insert the supplied CD-ROM into your drive. If the setup program does not start
automatically, run Netcam_Setup.exe in the root folder. You will see the Welcome screen
shown below.
Figure 4: Welcome Screen
2. Click the Setup button to start the setup Wizard.
3. The next screen will list all the LevelOne IP Network Cameras on your LAN. An example
screen is shown below.
Figure 5: Camera List Screen
7