Filter
Top Products
43
Chapter 8: Using The Wireless-B Internet Video Camera’s Web-based Utility
Setup
Wireless-B Internet Video Camera
Wireless Settings
SSID. Enter the network’s SSID or network name here.
Network Type. Select the network’s mode, Infrastructure or Ad-hoc.
Domain. Keep the default setting, USA.
Channel No. If the Camera is set to ad-hoc mode, select its channel setting from the drop-down menu.
WEP. To use WEP encryption, click the Enable radio button. Then click the Edit WEP Settings button. For more
information, go to the “WEP Key Settings” section. To disable WEP encryption, click the Disable radio button.
To save your changes, click the Apply button. To cancel any unsaved changes, click the Cancel button. To get
additional information about the screen’s features, click the Help button.
WEP Key Settings
Configure the Camera’s WEP encryption settings on this screen (see Figure 8-6). Make sure all devices on your
wireless network use the same settings.
Default Transmit Key. Select which WEP key (1-4) will be used when your network’s access point or wireless
router sends and receives data.
WEP Encryption. Select the level of WEP encryption you wish to use, 64 Bit Keys (10 Hex chars) or 128 Bit
Keys (26 Hex chars).
Passphrase. Instead of manually entering WEP keys, you can use a Passphrase to generate them. It is case-
sensitive and should not be longer than 16 alphanumeric characters. (This Passphrase is compatible with Linksys
wireless products only. If you are also using non-Linksys wireless products, you will need to enter your WEP keys
manually on those products.) After entering the Passphrase, click the Generate button to create WEP key(s).
Key 1-4. If you are used a Passphrase, the WEP keys will be displayed after you have generated them. If you are
not using a Passphrase, manually enter a set of values in each field. (For 128-bit WEP, only one WEP key is
permitted.) If you are using 64-bit WEP encryption, then each key must consist of exactly 10 hexadecimal
characters. If you are using 128-bit WEP encryption, then the key must consist of exactly 26 hexadecimal
characters. Valid hexadecimal characters are “0” through “9” and “A” through “F”.
Authentication. The default is set to Open System, for which the sender and the recipient do NOT use a WEP key
for authentication. You can also choose Shared Key, when the sender and recipient use a WEP key for
authentication. This setting should match the one on your network’s access point or wireless router.
Figure 8-6: WEP Key Settings