Filter
Top Products
16
Basic Shooting and Playback Operations
3 Press the shutter-release button
halfway.
• When the subject is in focus, the focus
area or focus indicator is displayed in
green.
• When you are using digital zoom, the
camera focuses in the center of the
frame and the focus area is not
displayed.
• If the focus area or focus indicator
flashes, the camera is unable to focus.
Modify the composition and try pressing
the shutter-release button halfway
again.
4 Without lifting your finger, press
the shutter-release button the rest
of the way down.
B Notes About Saving Images or Movies
The indicator showing the number of exposures remaining or the indicator showing
the remaining recording time flashes while images or movies are being saved. Do
not open the battery-chamber/memory card slot cover or remove the
battery or memory card while an indicator is flashing. Doing this could result in
loss of data, or in damage to the camera or the memory card.
C The Auto Off Function
• When no operations are performed for about one minute, the monitor turns off,
the camera enters standby mode, and then the power-on lamp flashes. The
camera turns off after remaining in standby mode for about three minutes.
• To turn the monitor back on while the camera is in standby mode, perform an
operation such as pressing the power switch or shutter-release button.
C When Using a Tripod
• We recommend using a tripod to stabilize the camera in the following situations:
- When shooting in dim lighting with the flash mode (A23) set to W (off)
- When the zoom is at a telephoto position
• When using a tripod to stabilize the camera during shooting, set Photo VR to Off
in the setup menu (A87) to prevent potential errors caused by this function.
F3.3
F3.3
1
/
250
1
/
250