Filter
Top Products
F13
Technical Notes and Index
Location Data Functions
The PictBridge
startup screen is
not displayed
when the
camera is
connected to a
printer.
With some PictBridge-compatible printers, the
PictBridge startup screen may not be displayed and
it may be impossible to print images when Auto is
selected for Charge by computer in the setup
menu. Set the Charge by computer to Off and
reconnect the camera to the printer.
47, 54
Images to be
printed are not
displayed.
• The memory card contains no images.
• Remove the memory card to print images in the
internal memory.
–
7
Cannot select
paper size with
the camera.
The camera cannot be used to select the paper size
in the following situations, even when printing from
a PictBridge-compatible printer. Use the printer to
select the paper size.
• The printer does not support the paper sizes
specified by the camera.
• The printer automatically selects the paper size.
–
Problem Cause/Solution A
Unable to
identify the
location or it
takes time to
identify the
location.
• The camera may not be able to identify the
location in some shooting environments. To use
the location data functions, use the camera as
much as possible in an open-air area.
• When positioning for the first time or when
positioning was unable to be performed for about
2 hours, it takes a few minutes to obtain the
location data.
E33
Unable to record
location data on
shot images.
When z or y is displayed on the shooting screen,
the location data is not recorded. Before shooting
images, check the location data reception.
E34
Difference
between the
actual shooting
location and
recorded
location data.
The acquired location data may deviate in some
shooting environments. When there is a significant
difference in the signals from the positioning
satellites, there could be a deviation of up to several
hundred meters.
E33
Problem Cause/Solution A