Filter
Top Products
Connecting the Camera to a Personal Computer with the F100
To connect the Nikon F100 camera to your personal computer, use only Nikon
Personal Computer Connecting Cord MC-33 or
MC-31.
A data link cannot be estab-
lished with any other connecting
cord.
Connecting
1.
Turn off both the camera and personal computer.
2.
Connect the MC-33 or MC-31 to the camera's
10-pin remote terminal.
Insert the cord's plug into the terminal with the
"A" symbol pointing to the dot at the upper left
of the terminal, then turn the lock screw as far as
it will go. (Fig. 9)
3. Connect the MC-33 or MC-31 to the personal
computer's RS-232C serial port.
Match the shape of the cord's connector with
the personal computer's terminal, then push it in
and tighten the two screws on the
plug.
4.
Turn the computer on, start Windows®, then
turn the camera on.
Disconnecting
1.
Guit Windows®, then turn off both the camera
and personal computer.
2.
Remove the cord's connector from the personal
computer.
Loosen the two screws on the connector, then
pull it out.
3. Remove the cord's plug from the camera body.
Unscrew the lock
ring,
then unplug the
cord.
(Fig.
10)
(Fig.
10)
11