Filter
Top Products
(Fig.
13)
Connecting the Camera to a Personal Computer
with the F90/F90X (N90/N90s)
To connect the Nikon F90/F90X (N90/N90s) camera to your personal computer, you
must use Nikon Personal Computer Connecting Cord
MC-31.
You cannot establish a
data link with any other connecting
cord.
Connecting
1.
Turn the camera and personal computer off.
2.
Connect the MC-31 to the camera's 10-pin
remote terminal.
Insert the cord's plug into the terminal with the
"A" symbol pointing up, then turn the lock screw
as far as it will go. (Fig. 13)
3. Connect the MC-31 to the personal computer's
RS-232C serial port.
Match the shape of the cord's connector with
the personal computer's terminal, then push it in
and tighten the two screws on the
plug.
4.
Turn the computer
on,
start Windows®, then
turn the camera on.
YV\\\IV'J ®1
Riii»
l vL-^¥m it '
$01
i
1
\
i
Disconnecting
1.
Quit Windows®, then switch off both camera
and personal computer.
2.
Remove the cord's connector from the personal
computer.
Loosen the two screws on the connector, then
pull it out.
3. Remove the cord's plug from the camera body.
Unscrew the lock
ring,
then unplug the
cord.
(Fig.
14)
(Fig.
14)
13