Filter
Top Products
54
Features That Can Be Set Using the Multi Selector
Shooting Features
Flash Modes (Using the Flash)
You can set a flash mode that suits the shooting conditions.
1 Press H (m flash mode) on the multi selector.
2 Press the multi selector to select the desired
mode and press the k button.
• See “Available Flash Modes” (A55) for more
information.
• If the k button is not pressed within a few seconds,
the selection will be canceled.
• When U (auto) is applied, D is only displayed for
a few seconds, regardless of Photo info settings
(A94).
3 Frame the subject and take a picture.
• The flash lamp indicates the status of the flash when
you press the shutter-release button halfway.
- On: The flash will fire when you press the shutter-
release button all the way.
- Blinking: The flash is charging. The camera cannot
take pictures.
- Off: The flash will not fire when a picture is taken.
• If the battery is low, the monitor will be turned off
while the flash is charging.
C Effective Range of the Flash
The flash has a range of about 0.3 to 3.5 m (1 ft to 11 ft) for wide-angle position, and about
0.5to2.2m (1ft 8in. to 7ft 2in.) for telephoto zoom position (when ISO sensitivity is set to Auto).
Flash mode