Filter
Top Products
Technical Notes
108
The battery inserted
in the camera cannot
be charged.
• Confirm all connections.
•
When connected to a computer, the camera may
not charge for any of the reasons described below.
- Off is selected for Charge by computer in
the camera settings menu.
- Battery charging stops if the camera is
turned off.
- Battery charging is not possible if the
camera’s display language and date and
time have not been set, or the date and
time were reset after the camera’s clock
battery was exhausted. Use the Charging
AC Adapter to charge the battery.
- Battery charging may stop when the
computer enters sleep mode.
- Depending on the computer specifications,
settings, and status, battery charging may
not be possible.
9
87
–
11, 13
–
–
The monitor is hard
to read.
• Adjust the monitor brightness.
• The monitor is dirty. Clean the monitor.
82
103
E flashes on the
screen.
• If the camera clock has not been set, E
flashes on the shooting screen, and images
and movies saved before the clock is set are
dated “00/00/0000 00:00” and “01/01/2015
00:00” respectively. The shooting date and
time of still images is not displayed during
playback. Set the correct time and date for
Date and time in the camera settings menu.
• The camera clock is not as accurate as ordinary
watches or clocks. Periodically compare the
time of the camera clock with that of a more
accurate timepiece and reset as required.
3, 80
Date and time of
recording are not
correct.
Date stamp not
available.
Date and time has not been set in the camera
settings menu.
80
Date not stamped on
images even when
Date stamp is
enabled.
• The current shooting mode does not support
Date stamp.
• The date cannot be stamped on movies.
82
Problem Cause/Solution A