Filter
Top Products
xv
Introduction
Notes About Operating Temperature and
Humidity and Condensation
The operation of this camera has been tested at temperatures –10°C – +40°C
(14°F–104°F).
When you use the camera in cold climate regions, observe the following
precautions. Keep the camera and spare batteries in a warm place before use.
• The performance of the batteries (number of pictures shot and shooting
time) will drop temporarily.
• If the camera is in a very cold state, the performance may drop temporarily,
for example, the monitor may be darker than normal immediately after the
camera is turned on or residual images may be produced.
• When snow or water droplets adhere to the exterior of the camera,
immediately wipe them off.
- If the buttons or switches are frozen, they may not operate smoothly.
- If the microphone or speaker openings are clogged with water droplets,
the sound may deteriorate or become distorted.
bOperating environmental conditions such as
temperature and humidity may cause fogging
(condensation) on the inside of the monitor,
lens, or flash window.
This is not a camera malfunction or defect.
bEnvironmental conditions that are likely to
cause condensation inside of the camera
Fogging (condensation) may occur on the inside of the monitor, lens, or flash
window in the following environmental conditions where there are sharp
temperature changes or high humidity.
• The camera is suddenly immersed in low temperature underwater from
high temperature on land such as the beach or places under direct sunlight.
• The camera is moved from a cold place to a warm place, such as inside a
building.
• The battery-chamber/memory card slot cover is open or closed in a high-
humidity environment.
bClearing the fogging
• Open the battery-chamber/memory card slot cover after turning off the
camera in a place where the ambient temperature is stable (avoid any place
that has high temperature/high humidity, sand or dust).
• To clear the fogging, remove the battery and memory card, and leave the
camera with the battery-chamber/memory card slot cover open to allow
the camera to adjust to the ambient temperature.
• If the fogging does not clear, consult your retailer or Nikon-authorized
service representative.