Filter
Top Products
181
Troubleshooting
Technical Notes and Index
Monitor is hard to read.
• Adjust monitor brightness.
• Monitor is dirty. Clean monitor.
152
171
Date and time of recording are
not correct.
• If camera clock has not been set, “Date not
set” indicator blinks during shooting and
movie recording. Pictures and movies
recorded before clock is set are dated “00/00/
0000 00:00” or “01/01/2011 00:00”
respectively. Set the correct time and date
from the Time zone and date option in the
setup menu.
• Check camera clock regularly against more
accurate timepieces and reset as required.
22, 149
149
No indicators displayed in
monitor.
Playback is set to Auto info for Monitor
settings in the setup menu.
152
Print date not available.
Time zone and date setting is not applied in
the setup menu.
22, 149
Date not appearing on pictures
even when Print date is
enabled.
• The current shooting mode is one that does
not support Print date.
• Date cannot be imprinted on movies.
153
Time zone and date setting
screen appears when the
camera is turned on.
Clock battery is exhausted; all settings were
restored to their default values.
22, 150
Camera settings reset.
Monitor turns off, and the
power-on lamp blinks rapidly.
Battery temperature is high. Turn off camera and
allow battery to cool down before resuming use.
After the lamp blinks for three minutes, the
camera will turn off automatically. Pressing the
power switch also turns off the camera.
21
Problem Cause/Solution A