Filter
Top Products
178
Troubleshooting
Technical Notes and Index
Electronically Controlled Cameras
In extremely rare instances, unusual characters may appear in the monitor and the
camera may stop functioning. In most cases, this phenomenon is caused by a
strong external static charge. Turn the camera off, remove and replace the battery,
then turn the camera on again. In the event of continued malfunction, contact
your retailer or Nikon-authorized service representative. Note that disconnecting
the power source as described above may result in the loss of any data not
recorded to internal memory or the memory card at the time the problem
occurred. Data already recorded will not be affected.
Date and time of recording are
not correct
• If camera clock has not been set, “Date not
set” indicator blinks during shooting and
movie recording. Pictures and movies
recorded before clock is set are dated “00/00/
0000 00:00” or “01/01/2010 00:00”
respectively. Set the correct time and date
from the Date option in the setup menu.
• Check camera clock regularly against more
accurate timepieces and reset as required.
20
148
No indicators displayed in
monitor
Auto info is selected for Playback in Monitor
settings of the setup menu.
151
Date imprint not available
• Camera clock has not been set.
• Another function that restricts the Date
imprint option is enabled.
20, 148
76
Date not imprinted on pictures
even when Date imprint is
enabled
• Another function that restricts the Date
imprint option is enabled.
• Selected shooting mode does not support
date imprint
76
152
Camera settings reset
Clock battery is exhausted; all settings were
restored to their default values.
149
Monitor turns off, and the
power-on lamp blinks green
rapidly.
Battery temperature is high. Turn off camera and
allow battery to cool down before resuming use.
19
Battery inserted into the
camera is not charged when
the camera is connected to a
computer.
• The battery is not charged when the camera
is turned off.
• Charging stops if the computer enters sleep
mode while the battery is charging. The
camera may be turned off.
• Depending upon computer specifications,
settings, and status, it may be impossible to
charge the battery inserted into the camera
via computer connection.
137
137
137
Problem Cause/Solution
A