Filter
Top Products
85
Technical Notes
Cleaning
Lens
One key to cleaning the lens is to not touch it with your fingers. Use a blower
(typically a small device with a rubber bulb attached to one end that you
pump to produce a stream of air out the other) to remove dust or lint. To
remove fingerprints or other stains that can not be removed with a blower,
wipe the lens with a soft cloth, using a spiral motion that starts in the center
of the lens and works out to the edges.
Monitor
Remove dust or lint with a blower. To remove fingerprints and other stains,
clean the monitor with a soft, dry cloth, being careful not to apply pressure.
Body
Use a blower to remove dust and lint, then wipe gently with a soft, dry cloth.
After using the camera at the beach or seaside, wipe off any sand or salt with
a cloth lightly dampened with fresh water, then dry thoroughly.
Do not use alcohol, thinner, or other volatile chemicals
Avoid Contact with Liquid Crystal
Should the monitor break, care should be taken to avoid injury due to broken
glass and to prevent the liquid crystal from the monitor touching the skin or
entering the eyes or mouth.
Notes on the Monitor
•The monitor may contain a few pixels that are always lit or that do not light.
This is a characteristic common to all TFT LCD monitors and does not indi-
cate a malfunction. Images recorded with the product will not be affected.
•Images in the monitor may be difficult to see in a bright light.
•The monitor is lit by an LED backlight. Should the monitor begin to dim or
flicker, contact your Nikon service representative.