Filter
Top Products
-BASIC
OPERATION-confinued----------
8
Attach
the
flash
unit
to
.
the
camera's
accessory
shoe.
Notes:
1)
If you are using an F3-series camera, make
sure that the ASAIISO film speed
is already
set on the camera before attaching the flash
unit,
as the camera's ASAIISO dial cannot
be
changed
after
the flash is attached to the
accessory shoe.
2) For the Nikonos-V camera, an optional
V-
Type
Sync Cord is required. For details about flash
unit attachment to the Nikonos-V, refer to the
Sync Cord's instruction manual.
10
With the 5B·
16A
, turn the locking
ring
@ around the mounting foot @
counterclockwise until
the
AS-8
's
foot
is
uncovered (fig.
1)
.
Then
slide
the
mounting foot onto
the
camera's
accessory shoe
as
far
as
it will
go
(fig.
2)
. Finally, tighten
the
locking
ring
to prevent
the
unit from acci-
dentally slipping off (fig.
3)
.
With the 5B·
16B
, turn the locking
nut
@)
on
the mounting foot ® coun-
terclockwise until
it
reaches its upper
limit (fig.
1)
.
Then
slide the mounting
foot forward into the shoe
as
far
as
it
wil
l go (fig.
2)
. Finally, tighten
the
locking nut to prevent the unit from
accidentally slipping off (fig.
3)
.