Filter
Top Products
Installing the EtherSpeedII Switch Modules
207344-B 3-5
5.
To seat the module onto the backplane, push the inserter/extractor levers
inward toward the module (Figure 3-5
).
Figure 3-5. Seating the Module
When the front panel of the module is flush with the front of the chassis, the
module backplane connectors are properly seated.
6. Use the flat-tip screwdriver to tighten the captive retaining screw at each
end of the module front panel.
Note: The captive retaining screws on the module must be tightened to at least
2 inch-pounds, but no more than 4 inch-pounds, of torque. Finger tightening is
also adequate. Do not overtighten.
6537FA