Filter
Top Products
Using the Centillion EtherSpeedII Switch Modules
4-2 207344-B
EtherSpeedII Switch Module Startup Failure
Symptom: All LEDs are solidly lit (do not blink) on the switch module.
To resolve the problem:
1. Ensure that an MCP module is present and operational with the
appropriate version of software.
• The EtherSpeedII 10/100BASE-T switch module requires version
4.1.2 software or greater.
• The EtherSpeedII 100BASE-FX switch module requires version
4.2.1 software or greater.
2. Ensure that all modules in the chassis are firmly seated and that the
retaining screws have been tightened.
3. Remove and reinsert the failing module.
If the problem persists, contact the nearest Nortel Networks Technical
Solutions Center.