Filter
Top Products
68
Remote control shooting
5
Advanced shooting
TIPS
The self-timer/remote control lamp does not blink after pressing
the shutter button on the remote control device.
Æ The remote control device may be too far from the camera. Move
closer to the camera and press the shutter button on the remote
control device again.
Æ The battery of the remote control device may be exhausted.
“How to replace the battery (CR2025) of the remote control
device” (P.132)
To cancel the remote control mode.
Æ The remote control mode is not canceled automatically after
shooting. Perform step 3 on page 67 and set the mode to
/ OFF.
• If the remote control receiver is exposed to strong light, the effective
signal distance may be reduced or shooting may not take place.
• To shoot sequential shots using the remote control device, press
and hold the shutter button on the remote control device. If the
camera does not receive the remote control signal properly,
sequential shooting may stop.
Note