Filter
Top Products
27
The camera’s internal battery saves the date and
time. “ ” appears on the screen of the
viewfinder or LCD when the internal battery is
running low on charge.
Do the following to recharge it.
Reset the date and time when fully recharged.
1 Connect the AC adapter. (Page 10)
2 Leave the POWER switch at OFF.
3 Leave the camera-recorder like this for about 4
hours.
• The internal battery charges during this time.
• Recharge the battery regularly to ensure
correct TC and menu operations.
Setting user information allows you to store 8-digit
information (such as the date and time) in the
hexadecimal format on the tape’s sub code track.
User information is automatically saved in the
memory and retained after you turn off the power.
1 Set the POWER switch to ON.
2 In the setup menus, RECORDING SETUP
screen UB MODE, select USER.
• For menu operation (Page 66)
• You can also use the menu buttons on the
remote control. (Page 19)
3 Move the OPERATION lever r to select UB
PRESET.
4 Press the OPERATION lever [h] (or move it
y), move it r to select YES and press [h]
again.
5 The following screen appears, so use the
OPERATION lever to set the user information.
Move the OPERATION lever e or r to select
the characters for the user information.
• You can use numbers from 0 to 9 and letters
from A to F.
Move the OPERATION lever t or y to
move to the next digit.
Recharging the built-in battery
Setting user information
RECORDING SETUP
PUSH MENU TO RETURN
UB PRESET
UB MODE
REC TIME
ONE-SHOT REC
OFF
0.5
S
TC PRESET
- - - -
- - - -
RECORDING SETUP
PUSH MENU TO RETURN
UB PRESET
UB MODE
REC TIME
ONE-SHOT REC
OFF
0.5
S
USER
TC PRESET
- - - -
RECORDING SETUP
PUSH MENU TO RETURN
UB PRESET
REC TIME
ONE-SHOT REC
0.5
S
YES
UB MODE
USER
TC PRESET
- - - -
UB PRESET
PUSH MENU TO RETURN
0 0 0 0 0 0 0 0
+/
-
SEL
: PUSH PLAY/STOP
: PUSH REW/FF
UB PRESET
PUSH MENU TO RETURN
F 0 0 0 0 0 0 0
+/
-
SEL
: PUSH PLAY/STOP
: PUSH REW/FF
UB PRESET
PUSH MENU TO RETURN
F 0 0 0 0 0 0 0
+/
-
SEL
: PUSH PLAY/STOP
: PUSH REW/FF
Preparations