Filter
Top Products
66
Setting the recording time code
(continued)
Specifying the time code (TC PRESET)
(continued)
5 After the time code value has been set,
press .
6 Using , move to “YES”, and press .
TC PRESET
PRESET OK?
NO
PUSH SET
YES
___
7 Press [MENU/MODE CHK] 2 times to release
the menu mode.
Set the user’s bit
Setting user’s bit allows you to store 8-digit
information (such as the date and time) in the
hexadecimal format on the sub code area.
User’s bit is automatically saved in the memory
and retained after you turn off the power.
1 Hold down [POWER] for at least 1 second to
turn the power on.
2 Select “OFF” for the “EXT UB REGEN” item
on the setting menu “TIMECODE SETUP”.
Basic operations on the setting menus (Page
88)
3 Select “USER” for the “UB MODE” item on
“TIMECODE SETUP”.
4 Select “CHANGE” for the “UB PRESET”
item on “TIMECODE SETUP”, and press .
TIMECODE SETUP
PUSH MENU TO RETURN
TCG
TC PRESET
TC MODE
EXT UB REGEN
REC RUN
ON
UB MODE
USER
VITC BLANK
>>>
EXT TC REGEN
DF
OFF
CHANGE
UB PRESET
RETURN
•
5 Set the user’s bit.
Using and , select the user’s bit characters.
You can use numbers from 0 to 9 and letters
from A to F.
UB PRESET
0 0 0 0 0 0 0 0
PRESET : PUSH SET
+/
-
SEL
: PUSH
: PUSH
/
/
Using , move to the next digit, and press
and again to select the character.
UB PRESET
0 0 0 0 0 0 0 0
PRESET : PUSH SET
+/
-
SEL
: PUSH
: PUSH
/
/
If [RESET] is pressed while setting the user’s bit,
the user’s bit value will be reset to zero.
6 After the user’s bit has been set, press .
7 Using , move to “YES”, and press .
UB PRESET
PRESET OK?
NO
PUSH SET
YES
___
8 Press [MENU/MODE CHK] 2 times to release
the menu mode.
•
Recording data on P2 cards (continued)