Panasonic AG-HPG20E Camera Accessories User Manual


 
List of setting menus (continued)
The underlined settings are the factory mode settings.
96
TIMECODE SETUP screen (continued)
Item Description of settings
VITC POS-2
This is used to set the insert position of VITC signal.
(When 59.94 Hz has been set)
10L
I
18L
I
20L
(When 50Hz has been set)
7L
I
13L
I
22L
<Note>
You cannot select the same line as the lines for “VITC POS-1” on the “TIMECODE
SETUP” screen or “UMID POS” on the “AV OUT SETUP” screen.
This setting is effective only for VIDEO output and SD-SDI output.
HD EMBD VITC This is used to set whether to superimpose the VITC information onto HD-SDI output
or not.
ON:
Superimpose
OFF:
Not superimpose
HD EMBD LTC This is used to set whether to superimpose the LTC information onto HD-SDI output
or not.
ON:
Superimpose
OFF:
Not superimpose