Filter
Top Products
126
Eye cup holder
Eye cup
Projection
System resetting
Reset the system microcomputer if you can no
longer operate the camera-recorder even though
its power is on or a similar kind of a problem has
occurred.
Use a pointed object to press the RESET button on
the camera-recorder.
The menu setting entered and memory contents
will not be cleared even when the system is reset.
Do not press the RESET button when the camera-
recorder is operating normally.
Cleaning
When cleaning, do not use benzene or thinner.
• Using benzine or paint thinners may deform the
camera-recorder and/or cause the surface fi nish
to peel off.
• Before proceeding with maintenance, remove the
battery or disconnect the AC cord from the power
outlet.
• Use a soft, clean cloth to wipe the camera-
recorder. To remove stubborn dirt, wipe the
camera-recorder with a cloth moistened with
kitchen detergent that has been diluted with
water and then use a dry cloth to take up the
remaining moisture.
Cleaning the Viewfi nder
If there is dust inside the view fi nder, remove the
eye cup holder and get rid of the dust.
• The interior of the eye cup holder is specially
fi nished, so do not ever wipe it. If there is dust on
it, blow it off with an air blower.
• Remove the eye cup holder with the eye cup
attached by rotating it counterclockwise. (It will
be tightly screwed on.) When you do this, tilt the
view fi nder slightly upward.
• To amount the eye cup holder, align the ridges
and grooves of the eye cup holder and camera-
recorder, and turn clockwise until the holder
clicks into place.
CH 1 SELECTCH 2 SELECT
INPUT 1 INPUT 2
INT(L)
INPUT 1
INPUT 2
INT(R)
INPUT 2
ON
OFF
BARS
AUDIO
SHUTTER
SPEED SEL
COUNTER RESET/TC SET
ZEBRA OIS
RESET
ON
OFF
MIC POWER +48V
RESET button