Filter
Top Products
28
1 Lift up the viewfi nder and open the card slot
cover.
• Check that the P2 card access lamp is not
blinking orange.
2 Press the card eject button once, and when
the button has popped back up, press it
again.
3 Remove the P2 card.
1
2
3
• Do not eject a P2 card while its data is being
accessed or while it is being recognized after
insertion (the P2 card access lamp is blinking
orange).
• If a P2 card is ejected during formatting or while
its data is being accessed, “TURN POWER
OFF” appears in the viewfi nder, and a warning
is indicated by an alarm or tally lamp. If this
happens, turn the power off and back on again.
When a card is ejected during formatting:
Format the card again.
When a card is ejected while its data is being
accessed:
The data on the card will not be destroyed, but
the clips may be thrown out of order. Check the
clips and repair them. (For details on repairing
clips, see page 69.)
• During playback, a P2 card inserted into the
empty slot will not be recognized and the P2
card access lamp will not light. When playback is
completed, the P2 card recognition will begin.
• You can use ACCESS LED on the OTHER
FUNCTIONS screen to set the P2 card access
lamps so that they will always be off. In this case,
either turn off the power or wait until enough time
has passed after inserting the cards or stopping
operation before ejecting the cards.
• If a P2 card is ejected while thumbnails are
displayed, the thumbnail screen is released.
Card eject button
Basic shooting operations (P2 card) (continued)
Remove the P2 card
P2