Filter
Top Products
145
Maintenance and Inspections : Warning System
Maintenance and Inspections
If a problem is detected immediately after the power is turned on, or during operation, this will be indicated by the
WARNING lamp, lamps inside the viewfinder and a warning tone.
Note
The WARNING lamp has the highest priority, followed by the tally lamp, and then the warning tone. When multiple errors
occur simultaneously a higher priority indication will be triggered. The [WIRELESS RF], however, may not be indicated,
depending on the menu setting.
Warning System
Warning Description Tables
1. System Errors
Display window
indication
The error code lights up.
WARNING lamp
Blinks 4 times per second.
Tally lamp Blinks 4 times per second.
Viewfinder
The SYSTEM ERROR indication and the
error code light up.
Warning tone Beeps continuously.
Warning
description
An error in the reference signal or the
communication.
Recording/
playback
operation
The operation stops.
Countermeasures
Please confirm [Error Codes] (page 148)
and consult your distributor.
3. Battery Empty
Display window
indication
All 7 bar indicators for battery remaining
capacity start blinking.
WARNING lamp
Lights up.
Tally lamp Blinks once per second.
Viewfinder The BATT LED lights up.
Warning tone Beeps continuously.
Warning
description
The battery has run out.
Recording/
playback
operation
The operation stops.
Countermeasures
Replace the battery.
2. Card removal error
Display window
indication
Error code E-30 blinks.
WARNING lamp
Blinks 4 times per second.
Tally lamp Blinks 4 times per second.
Viewfinder
The “TURN POWER OFF” indicator lights
up.
Warning tone
Continues to beep.
Warning
description
The P2 card being accessed has been
removed, resulting in an error in the internal
memory of the camera-recorder.
Recording/
playback
operation
Cannot be performed.
Countermeasures
Turn off the power to the camera-recorder. If
there is an error in a clip on the removed P2
card, repair the clip.
4. Write-protect
Display window
indication
All 7 bar indicators for remaining MEDIA
capacity start blinking.
WARNING lamp
This lamp will illuminate continuously until an
operation is made after recording.
Tally lamp
This lamp will flash 4 times every second
until an operation is made after recording.
Viewfinder The WP indicator lights up.
Warning tone
This tone will sound continuously until an
operation is made after recording.
Warning
description
The inserted P2 cards are write-protected.
Recording/
playback
operation
Recording is disabled.
Countermeasures
Disable the write-protect or replace the P2
card.
AJ-HPX2000P(VQT1D27-1)E.book 145 ページ ２００７年７月３０日 月曜日 午後１時３１分