Filter
Top Products
114
Preparation: Power Supply
1 Mount the Anton/Bauer battery pack.
a. Power supply output connector for lighting
b. Anton/Bauer battery pack
c. Lighting control switch
<For your information>
The Anton/Bauer battery holder includes both a power
supply output connector for lighting and a lighting control
switch, which are convenient when attaching a light. Please
contact Anton/Bauer for information about the lighting
system.
2 Insert the battery and slide it in the direction of the
arrow.
d. Release lever
<For your information>
Removing the battery pack
Completely push down and hold the release lever on the
battery holder. Then, slide the battery pack in the
opposite direction to the arrow while holding the lever
down.
3 Setting the battery type.
Select the battery type listed under BATTERY SELECT.
Select BATTERY SELECT from the <BATTERY/
P2CARD> screen on the MAIN OPERATION page.
Please refer to [BATTERY SETTING1] (page 196) for
more information.
The following Anton/Bauer batteries can be used:
PROPAC14
TRIMPAC14
HYTRON50
HYTRON140
DIONIC90
DIONIC160
Mounting the Battery and Setting the Battery Type
Using an Anton/Bauer Battery Pack
a
b
c
d
AJ-HPX3700G-VQT1V68_eng.book 114 ページ ２００８年１０月１５日 水曜日 午後６時３８分