Filter
Top Products
58
Adjustments and Settings for Recording
: Setting the Electronic Shutter
To place the unit in SYNCHRO SCAN mode, follow the steps
below.
1 Press the SHUTTER switch positioned at [ON] towards
[SEL], to place the unit in SYNCHRO SCAN mode or
SYNCHRO SCAN2 mode.
2 In the SYNCHRO SCAN mode, it is possible to change
the shutter speed continuously by operating the
SYNCHRO SCAN (+/–) adjustment buttons.
a. SYNCHRO SCAN adjustment buttons (+/–)
b. SHUTTER switch
3 In SYNCHRO SCAN mode, the shutter speed display
can be switched between seconds and degrees.
For more details, refer to [SYNCHRO SCAN DISP.]
(page 185).
In SYNCHRO SCAN2 mode, the shutter speed can
only be displayed in seconds.
When the frame rate is low, pressing the SYNCHRO
SCAN adjustment buttons (+/–) to change the shutter
speed only gives a small change in the time, and
consequently the shutter value in the viewfinder
display may remain unchanged.
Note
When the VFR function is enabled, the variable ranges in
the SYNCHRO SCAN mode differs from those seen when
the VFR function is disabled.
Placing the Unit in SYNCHRO SCAN Mode
b
a
AJ-HPX3700G-VQT1V68_eng.book 58 ページ ２００８年１０月１５日 水曜日 午後６時３８分